Openvario
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
projects:gauge_00:top [2014/11/30 21:41] mihu created |
projects:gauge_00:top [2017/11/04 12:24] dieters |
||
|---|---|---|---|
| Line 4: | Line 4: | ||
| The gauge is a proof of concept only and not yet ready for publishing. It uses a stepper motor designed for automotive gauges (see http://guy.carpenter.id.au/gaugette/2012/05/25/buyers-guide/), an Arduino and the SwitecX25 Library provided by Guy Carpenter under a BSD license. An additional LED bargraph will display angle of attack measured by a DIY sensor mounted on the TE probe as an additional safety feature. | The gauge is a proof of concept only and not yet ready for publishing. It uses a stepper motor designed for automotive gauges (see http://guy.carpenter.id.au/gaugette/2012/05/25/buyers-guide/), an Arduino and the SwitecX25 Library provided by Guy Carpenter under a BSD license. An additional LED bargraph will display angle of attack measured by a DIY sensor mounted on the TE probe as an additional safety feature. | ||
| - | Stay tuned... | + | Download the [[ftp://ftp.openvario.org/Stick_Remote_Control_20140106.ino| firmware]]. |
| + | |||
| + | In the meantime the work around the Mechanical Gauge progressed, the current status can be seen in the [[https://forum.xcsoar.org/viewtopic.php?f=30&t=3062|XCSoar-Forum]] | ||
projects/gauge_00/top.txt · Last modified: 2017/11/04 12:24 by dieters
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International