Openvario
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
projects:series_00:build:housing [2016/01/15 19:56] dieters |
projects:series_00:build:housing [2016/01/15 20:00] dieters |
||
|---|---|---|---|
| Line 9: | Line 9: | ||
| {{ :projects:series_00:build:overview_parts.jpg?600 |}} | {{ :projects:series_00:build:overview_parts.jpg?600 |}} | ||
| - | |||
| - | {{ :projects:series_00:build:housing_build_1.jpg?300 |}} | ||
| {{ :projects:series_00:sam_2378_cr.gif?direct&600 |}} | {{ :projects:series_00:sam_2378_cr.gif?direct&600 |}} | ||
| + | |||
| + | {{ :projects:series_00:build:housing_build_1.jpg?600 |}} | ||
| The front frame is milled from a 20mm aluminum plate, note that most of this material is removed. This needs a better (stiffer and more powerful) router or a lot of patience than what is required for the sheet metal parts. The good news is, if you are OK with mounting the flight computer on the frontside of the instrument panel (like for example the Butterfly vario, versus behind the panel as most instruments) you can do without the front frame. | The front frame is milled from a 20mm aluminum plate, note that most of this material is removed. This needs a better (stiffer and more powerful) router or a lot of patience than what is required for the sheet metal parts. The good news is, if you are OK with mounting the flight computer on the frontside of the instrument panel (like for example the Butterfly vario, versus behind the panel as most instruments) you can do without the front frame. | ||
projects/series_00/build/housing.txt ยท Last modified: 2016/01/15 20:04 by dieters
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International