Differences

This shows you the differences between two versions of the page.

--- projects:series_00:build:top [2016/05/28 12:59]
dieters
+++ projects:series_00:build:top [2016/08/12 14:18]
dieters
@@ Line 6: / Line 6: @@
 ==== Bill of Material ====
-{{:projects:series_00:bom.png?nolink&100|}}Now that you've been warned, you can move on and start by getting all the [[projects:series_00:bom | components]] you need to build the Flight Computer.
+{{:projects:series_00:bom.png?nolink&50|}}Now that you've been warned, you can move on and start by getting all the [[projects:series_00:bom | components]] you need to build the Flight Computer.
 ==== Soldering ====
-{{:projects:series_00:build:solder.png?nolink&100 |}}
+{{:projects:series_00:build:solder.png?nolink&50 |}}
 Once your parts have arrived, go ahead, and start [[projects:series_00:build:soldering|soldering]] all components onto the PCBs.
 ==== Preparing the Housing ====
-{{:projects:series_00:build:tools.png?nolink&100 |}}
+{{:projects:series_00:build:tools.png?nolink&50 |}}
 Now it's time for the mechanics. Build the housing and the tube connectors. [[projects:series_00:build:housing|More...]]
 ==== Assembly ====
@@ Line 21: / Line 21: @@
 ==== Installing the Software ====
 Now that you have the Openvario Flight Computer hardware in place, it's time to continue with installing the [[projects:series_00:software:write_image_to_sd|software]].
+==== OpenVario Setup Guide ====
+Coming soon...
 ==== Testing the Device ====
-You're done. Time for celebration? Before connecting the device to a power source, make sure your DC/DC converter is set properly, and the connection to your DC source isn't reversed (we have included reverse voltage protection, just in case...). Then put in the SD-Card, turn on the power and ... wait. If everything runs smoothly, after around 15s you should see two tuxes {{:projects:series_00:build:tux.svg.png?100 |Tux }} on the screen and then see the Flight Computer booting into the XCSoar start screen. If not, time for troubleshooting by means of [[projects:series_00:electrical_tests:electrical_tests|electrical testing]].
+You're done. Time for celebration? Before connecting the device to a power source, make sure your DC/DC converter is set properly, and the connection to your DC source isn't reversed (we have included reverse voltage protection, just in case...). Then put in the SD-Card, turn on the power and ... wait. If everything runs smoothly, after around 15s you should see two tuxes {{:projects:series_00:build:tux.svg.png?50 |Tux }} on the screen and then see the Flight Computer booting into the XCSoar start screen. If not, time for troubleshooting by means of [[projects:series_00:electrical_tests:electrical_tests|electrical testing]].
 ==== Cockpit Installation ====