This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
sensorboard [2014/09/23 14:11] akw created |
sensorboard [2016/01/16 16:01] (current) dieters |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | Sensor Board | + | =====Sensor Board===== |
+ | [[flarm-hb9cv]] | ||
- | Generic Info | + | {{:ov_sensor_board.jpg?300 |}} |
+ | ====Generic Info==== | ||
- | Board is connected using I2C to the Cubieboard | + | Board is connected using I2C to the Cubieboard |
- | Sensors on Sensorboard | + | ====Sensors on Sensorboard==== |
- | 2x MS5611 | + | ==2x MS5611== |
- | Absolute pressure sensor | + | Absolute pressure sensor\\ |
- | Range 10 .. 1200 mbar | + | Range 10 .. 1200 mbar\\ |
- | Resolution up to 0.012 mbar | + | Resolution up to 0.012 mbar\\ |
- | Adr 0x77 and 0x76 (7Bit) | + | Adr 0x77 and 0x76 (7Bit)\\ |
- | Datasheet www.meas-spec.com/downloads/MS5611-01BA03.pdf | + | [[http://www.meas-spec.com/downloads/MS5611-01BA03.pdf|Datasheet]] |
+ | ==MPU9150== | ||
- | MPU9150 | + | Gyro, accelerometer, magnetometer and digital motion processor.\\ |
+ | Adr 0x68 (pin AD0 low) or 0x69 (AD0 high) (7bit)\\ | ||
+ | |||
+ | More information [[http://www.invensense.com/mems/gyro/mpu9150.html|here]].\\ | ||
+ | [[http://www.invensense.com/mems/gyro/documents/AN-MPU-9150EVB-00.pdf|Datasheet]] | ||
- | Gyro, accelerometer, magnetometer and digital motion processor | + | ==AMS5915== |
- | Adr 0x68 (pin AD0 low) or 0x69 (AD0 high) (7bit) | + | |
- | More information on http://www.invensense.com/mems/gyro/mpu9150.html | + | |
- | Datasheet http://www.invensense.com/mems/gyro/documents/AN-MPU-9150EVB-00.pdf | + | |
+ | Differential pressure sensor | ||
+ | Range 50mbar (max. 300 km/h IAS) | ||
+ | Resolution <0,004 mbar (50 mbar, FSO 13107 counts) | ||
+ | Adr 0x28 (7bit) | ||
+ | [[http://www.amsys.info/sheets/amsys.en.ams5915_e.pdf|Datasheet]] | ||
- | AMS5915 | + | == (MS4525HRD - Not installed on sensorboard, would be an alternative to AMS5915, not yet available)== |
- | Differential pressure sensor | + | Differential pressure sensor, possible alternative to AMS5915?\\ |
- | Range 50mbar (max. 300 km/h IAS) | + | 24bit resolution (overkill?) and nice form factor (barbed connectors sideways)\\ |
- | Resolution <0,004 mbar (50 mbar, FSO 13107 counts) | + | Pinout similar to AMS5915, maybe PCB layout could accomodate both sensors?\\ |
- | Adr 0x28 (7bit) | + | Adr 0x77 and 0x76 (7Bit) - same as MS5611 and MS5803\\ |
- | Datasheet http://www.amsys.info/sheets/amsys.en.ams5915_e.pdf | + | [[http://meas-spec.com/downloads/MS4525HRD.pdf|Datasheet]] |
- | (MS4525HRD - Not installed on sensorboard, would be an alternative to AMS5915, not yet available) | + | ==Temperature Sensor DS1820== |
- | Differential pressure sensor, possible alternative to AMS5915? | + | Temperature sensor shall be mounted in free airstream -> not mounted on PCB\\ |
- | 24bit resolution (overkill?) and nice form factor (barbed connectors sideways) | + | Connector 3.5mm stereo plug\\ |
- | Pinout similar to AMS5915, maybe PCB layout could accomodate both sensors? | + | LX8000/9000 uses the same sensor\\ |
- | Adr 0x77 and 0x76 (7Bit) - same as MS5611 and MS5803 | + | [[http://www.micropik.com/PDF/ds1820.pdf|Datasheet]]\\ |
- | Datasheet http://meas-spec.com/downloads/MS4525HRD.pdf | + | good accuracy, good form factor, not I2C but single wire interface |
- | Temperature Sensor DS1820 | + | ==Other stuff== |
- | Temperature sensor shall be mounted in free airstream -> not mounted on PCB | + | I2C to single wire bridge\\ |
- | Connector 3.5mm stereo plug | + | I2C EEPROM for calibration data storage\\ |
- | LX8000/9000 uses the same sensor | + | |
- | Datasheet DS1820 http://www.micropik.com/PDF/ds1820.pdf | + | |
- | good accuracy, good form factor, not I2C but single wire interface | + | |
+ | [[projects:series_00:software:nmea | NMEA_protocol to XCSoar]] | ||
- | Other stuff | ||
- | |||
- | I2C to single wire bridge | ||
- | I2C EEPROM for calibration data storage | ||
- | |||
- | |||
- | NMEA Protocoll to XCSoar | ||
Values provided to XCSoar | Values provided to XCSoar | ||
- | IAS (AMS5915) | + | IAS (AMS5915) |
- | Baro height (MS5611) | + | Baro height (MS5611) |
- | TEK pressure (MS5611) | + | TEK pressure (MS5611) |
- | Gyro and accelerometer (MPU9105) | + | Gyro and accelerometer (MPU9105) |
- | outside air temperature (??) | + | outside air temperature (??) |
- | Interface Programm "sensord" | + | [[sensord|Interface Programm "sensord"]] |