This is an old revision of the document!
Board is connected using I2C to the Cubieboard
Absolute pressure sensor Range 10 .. 1200 mbar Resolution up to 0.012 mbar Adr 0x77 and 0x76 (7Bit) Datasheet www.meas-spec.com/downloads/MS5611-01BA03.pdf
Gyro, accelerometer, magnetometer and digital motion processor Adr 0x68 (pin AD0 low) or 0x69 (AD0 high) (7bit) More information on http://www.invensense.com/mems/gyro/mpu9150.html Datasheet http://www.invensense.com/mems/gyro/documents/AN-MPU-9150EVB-00.pdf
Differential pressure sensor Range 50mbar (max. 300 km/h IAS) Resolution <0,004 mbar (50 mbar, FSO 13107 counts) Adr 0x28 (7bit) Datasheet http://www.amsys.info/sheets/amsys.en.ams5915_e.pdf
Differential pressure sensor, possible alternative to AMS5915? 24bit resolution (overkill?) and nice form factor (barbed connectors sideways) Pinout similar to AMS5915, maybe PCB layout could accomodate both sensors? Adr 0x77 and 0x76 (7Bit) - same as MS5611 and MS5803 Datasheet http://meas-spec.com/downloads/MS4525HRD.pdf
Temperature sensor shall be mounted in free airstream → not mounted on PCB Connector 3.5mm stereo plug LX8000/9000 uses the same sensor Datasheet DS1820 http://www.micropik.com/PDF/ds1820.pdf good accuracy, good form factor, not I2C but single wire interface
I2C to single wire bridge I2C EEPROM for calibration data storage
Values provided to XCSoar
IAS (AMS5915) Baro height (MS5611) TEK pressure (MS5611) Gyro and accelerometer (MPU9105) outside air temperature (??)