This is an old revision of the document!
The Cubieboard does not require special testing under normal circumstances. But there are some cable connections to be made which are required for a reliable function of your Openvario.
Cubieboard 2A20 (top view)
Test Point | Description | Nominal Value | Measured | Remarks |
---|---|---|---|---|
CT1 | CUBIE RX | LOGIC 3.3 V | Required for Debugging, connected to AT8, accessible from outside near RB4 | |
CT2 | CUBIE TX | LOGIC 3.3 V | Required for Debugging, connected to AT8, accessible from outside near RB4 | |
CT3 | CUBIE HP | TRIANGULAR | Headphone Output for Audio-Vario, connected to Sensorboard ST6. Volume Control is made using alsamixer |
Cubieboard 2A20 (bottom view) with twisted power supply cable ↔ DC-DC-converter output.
Test Point | Description | Nominal Value | Measured | Remarks |
---|---|---|---|---|
CB1 | CUBIE 5V | 5 V DC | Main Power Supply from DC-DC-Converter DT2 | |
GND | CUBIE GND | 0 V | Ground, connected to DC-DC-Converter GND |
Continue testing the Adapterboard
Continue testing the RJ45-Board
Continue testing the Sensorboard
Back to DC-DC-Converter
Back to Electrical Tests